Refco Tw-8 Torque Wrenches Kit

Refco Tw-8 Torque Wrenches Kit

Torque 10-75 Nm.

7 Heads – 17, 19, 22, 24, 26, 27, 29 mm.
Hard plastic carry case.

Part number
JAV-TW8

How to set a torque value:
1 Loosen the locking nut at the bottom of the handle
2 Determine the torque
3 The engraved numbers on the handle show 0, 18, 10 and 42. The engraved numbers on the
shaft show 10, 18, 42, 55, 65 and 75. You can set your torque anywhere between 10 and 75Nm.
Example torque setting at 44 Nm.
4 Turn the handle clockwise until the engraved 42 on the shaft is aligned with the 42 on the
handle. The central vertical lines should line up. Push down in the direction of the arrow.
5 Turn another 2 increments with the handle clockwise. The torque is now set at 44 Nm. Lock
the nut at the bottom of the handle.
Example torque setting at 56 Nm.
6 Turn the handle clockwise and until the engraved line 42 on the handle is aligned with the
middle line on the shaft and the top edge is aligned at the same time with the offset line of
the 42 marker on the shaft.
7 Keep turning clockwise by counting each marker that passes the middle line of the shaft until
you reach 56 Nm. The edge of the handle is now slightly above 55 Nm offset market line of
the shaft.
Safety Instructions & Operation Manual
EN
J